How to Save the Parameter Settings

Please save the parameters by following these steps:

Save current parameters into the USER1 or USER2 of the BC-100.

Step 1: Short press the SAVE button. At this time, the SAVE button will change from white to red. Simultaneously, the USER1 and USER2 buttons will flicker in red.

Step 2: Press USER1 or USER2. The pressed button will be lit in red for 1 second and then change back to white. Another button and the SAVE button will revert to white light directly. At this point, the operation of saving parameters into the USER1 or USER2 of the BC-100 is successfully completed.

Save Current Parameter Settings in the BC-100 to the MCU-400.

Step 1: Long press the SAVE button for 3 seconds; the button will then flicker in red until the current BC-100 settings are saved to the MCU-400 successfully.

Note: Only one set of parameters can be saved in the MCU-400. If users save a new set of parameters into the MCU-400, the previously saved one will be overwritten. Several parameters must be saved, including Frame Rate, Exposure Mode, White Balance, Gain Setting, IRIS, EV, Shutter, HDR, Brightness, Saturation, Contrast, Sharpness, 3D DNR, Audio Standard, and Audio Setting.